Toyota 8FBE18T, Operator'S Manual

Page: 8 / 53

8
Over load indicator (OPT)
Over load indicator lights and the buzzer sounds to
warn the operator if the detected weight goes over the
preset value when the operator is displaying the load
meter by the load display switch.
Height limiter indicator (OPT)
Height limiter indicator lights when height limiter is in
effect. For details, see “Height limiter”.
Traver 2nd speed setting indicator
This indicator comes on or goes off whenever the oper-
ator presses the travel 2nd speed control set switch.
This indicator is lit when the low speed is effect, limit-
ing the vehicle speed at a preset value. The speed con-
trol value can be set using the low speed setting screen.
Diagnostic mode indicator
If the key switch is turned to ON while any abnormal-
ity is occurring or if any abnormality occurs while the
vehicle is in use, this indicator blinks and the warning
buzzer sounds. At this time, a diagnosis error code is
displayed in the multi-screen display area. The error
code varies with each error location and error level.
Caution Caution Caution
If the diagnosis mode indicator is displayed, have
the vehicle inspected at a Toyota dealer.
Overheat warning indicator
Overheat indicator lights and buzzer sounds for five
seconds, to warn the operator in the case of tempera-
ture rise of traveling motor, pump motor, main circuit
or controller.
In error stage, the sound is kept until the error is recov-
ered. Although error code is not displayed on the
multi-function display, it is recorded by the system.
Overheating part is displayed on the screen:
C/R: Main controller
DCR: Traveling motor driver or main circuit
PCR: Pump motor driver or main circuit
DM: Traveling motor
PM: Pump motor
When overheated, the performance of vehicle is lim-
ited.
After the warning indicator is displayed, leave the
vehicle with the key switch on for a while (20 to 30
minutes).
Warning
If the warning indicator does not go out after 20 to
30 minutes, have it inspected immediately at a Toy-
ota dealer.
Other alarms and indicators
Return to neutral alarm
Buzzer sounds to warn the operator to be seated, to
release the accelerator pedal, and to return the direc-
tion lever to the neutral position before traveling.
It also sounds to warn the operator to return the mate-
rial-handling levers to the neutral position before mate-
rial handling.
Low temperature warning
Warning message is displayed on the multi-function
display and buzzer sounds when the traveling motor
driver or pump motor driver temperature is too low.
Display information:
COLD DCR: Traveling motor driver
COLD PCR: pump motor driver
When the low temperature warning is detected, the
performance of vehicle is limited.
Maintenance indicator
When the time set in the maintenance hour meter
comes, it will notify with the indicator display and a
buzzer sounds.
Travel and load handling control indicator
(Deluxe model with auto speed control only)
This indicator is displayed when the auto speed control
is active. See Auto speed control.
Over speed alarm
When the set speed is exceeded, the speed indicator
blinks and the buzzer sounds to inform the operator of
the over speed.
Unlike low speed setting, even if the set speed is
exceeded, any speed limitation is not applied.
The over speed value can be set using the over speed
alarm setting screen.
Shock indicator (OPT)
When the shock goes over the preset value, the shock
indicator blinks and the buzzer sounds, until the
administrator resets it.
See “Shock indicator display”.
(En-7)