Toyota 8FBE18T, Operator'S Manual

Page: 31 / 53

En
31
ON BOARD VEHICLE INSPECTION
Hydraulic oil level inspection
Park the vehicle on a level surface and lower the forks
to the ground before checking the level of the hydrau-
lic oil.
1. Remove the oil cap.
2. Wipe the level gauge attached to the oil cap with
clean cloth, and insert it again into the tank.
Note:
The oil level must be checked with the oil cap in con-
tact with the retainer inlet.
3. Extract the level gauge gently and check that the
oil adhesion is up to the level line.
Note:
The oil level varies with the maximum lifting height.
4. If the oil level is insufficient, add oil. Spilled or
splashed oil must be wiped off thoroughly.
Brake pedal inspection
1. Depress the brake pedal (1) fully, and check that
a sufficient reaction can be felt.
2. When the pedal is kept depressed, make sure that
it does not sink any further.
3. Also check that no abnormality of pedal depres-
sion and return movement is observed.
4. If abnormality of pedal depression is found, have
the vehicle inspected at a Toyota dealer.
Parking brake inspection
Pull the lever and check if the parking brake is active.
Return the lever to the original position and check if
the parking brake is released.
Warning
If an abnormality is found, have the vehicle
inspected at a Toyota dealer.
1
2
3
4
5
(1) Level line: At the maximum level line of forks,
≤
4000 mm
(2) Level line: At the maximum level line of forks,
4001 to 5000 mm
(3) Level line: At the maximum level line of forks,
5001 to 6000 mm
(4) Level line: At the maximum level line of forks,
6001 to 7000 mm
(5) Level line: At the maximum level line of forks,
7001 to 7500 mm
1
OPS indicator inspection
Sit in the seat, and turn the key switch to ON. Make
sure that the OPS indicator is not displayed on the
screen.
Caution Caution Caution
In any of the following cases, stop operation and
have the vehicle inspected by your Toyota dealer:
• The OPS indicator is not displayed on the screen
when the operator leaves the seat.
• The OPS indicator does not turn off when the
operator returns to the seat.
Inspection of measuring instruments
Measuring instruments are indispensable for under-
standing the vehicle status during operation. Turn the
key switch to ON to check the normal functioning of
each instrument.
Battery inspection
1. Perform the inspection after turning the key
switch to ON.
2. Check the battery charge indicator on the display
to see if the battery charge is sufficient.
Material handling system inspection
1. Check the forks for the installation position,
cracks and bending.
2. Check for mast distortion, chain tension and oil
leakage from cylinders and piping.
3. Operate the lift and tilt levers to check their func-
tioning.
Note:
• Be sure to perform full-stroke operation for each
cylinder piston a few times before starting daily
operation.
• If any abnormality is found, have the vehicle
inspected at a Toyota dealer.
(En-30)