31
SAFETY RULES:
•
Never operate the control handle together with the handlebar when starting the micro
tractor.
•
Never operate the equipment at high speed when going up or down a ramp. Never
•
Lower a ramp with the gearshift lever in the neutral position. Never operate both handles
(right, left) at the same time when operating at an elevation.
•
Never make a sharp turn when at high speed. Never operate the equipment at high speed
on a poor, uneven floor.
•
Never make a sudden draft if the plow blades are still on the ground.
•
Never disengage the clutch and, or drive, on a steep descent.
•
Never carry people;
•
Observe the operating conditions of the motor according to the descriptions in the
Operations Manual.
12. USE OF ROTARY ENGINE
A - Arm link bar structure
B - Gear lever
C - Nut
D - Main Housing
E - Rotary Hoes
F - Rotary spindle rear wheel assembly
G - Fixing brackets
Fig. 10
ASSEMBLY AND DISASSEMBLY OF ROTARY RIDING
The rotating hoe is engaged in the main housing D (Figure 10) of the tractor through 4
captive screws. To ensure correct fit of the gears, two guide pins are provided on the mounting
surface. If the cultivator gear is misaligned with the main box installed in the micro tractor, first
engage the rotating hoe and turn the clutch shaft or pulley slightly, then the gears will engage
properly. Two securing rods G are subsequently mounted one on each side between the structure
of the connecting rod of the arms A and the cover of the rotary spindle E. The disassembly of the
rotating spindle is in the reverse order of the assembly procedure.
First remove the two securing pins from the G stretcher, then loosen the four nuts C.
Cover the holes on the rotary hoe gearbox after disassembly to prevent any dirt from entering.
Summary of Contents for TDWT73(E)
