Toyama TDWT73(E), Manual

Page: 33 / 56

33
ROTARY BLADE ASSEMBLY -
PITCH DEPTH ADJUSTMENT
The hitch is made by shifting the gearshift lever to the left, and the trip is made by shifting
to the right. To avoid deformation of the gear lever, always engage the lever gently, not forcing it.
If the hoe shaft does not rotate while engaging the lever to the left, move the clutch / brake lever
gently to engage the clutch and move the lever to the left again.
A
– Rear wheel adjustment lever
B - Locking lever
C - Height adjustment tower
D - Rear wheel made of iron
Fig. 14 - Adjusment
A slight adjustment of plowing depth can be done by adjusting the rear wheel adjustment
lever A. If the desired depth cannot be reached, loosen the spring bracket by loosening the locking
lever B of the height adjustment tower C to increase depth.
TRANSFER BOX CURRENT TENSION ADJUSTMENT
1
– Suport
2
– Adjusting screw
3
– Locking screw
4
– Tension plate
Fig. 15
– Adjusting the transmission chain tension
If the chain in the transmission housing is frayed and loose, tighten the adjusting screw
(2) by hand until the chain is properly tensioned and then tighten the lock nut (3). If the bolt is
tightened with a wrench, special care must be taken to avoid any extra tightening, which will
damage the chain.