tousek GTZ-110 Digital, Mounting And Installation Manual

Page: 28 / 38

- 28 -
tousek / EN_GTZ-Digital_07 / 10. 10. 2019
Receiver RS 868-GTZ Transmitter RS 868-TXR-B
P1 memory button
P3
Memory button of the transmitter
(to activate the programming process through the transmitter)
P2 delete button
M1 memory
P2 A P1
M1
+
back side
P3
To replace the battery unscrew the screw at the back side and lift
the cover at the notch. Replace 3V-Lithium battery CR2032 as shown.
Give empty battery for recycling.
1
2
3
11. RADIO programming
GTZ 55, 110 Digital
Radio RS 868
• Your garage door opener kit is equipped with a 1-channel radio receiver RS-868 GTZ and a 4-channel transmitter
RS868-TXR-B.
• The pre-installed radio receiver board ( „4.3.3 Connection receiver“) has a selflearning technology, i.e. the codification
of the transmitter is memorized by the receiver.
• Furthermore, everytime you give and impulse, the code gets modified by the transmitter (rolling code).
• Due to this continuous alteration of the code, each code can be used only one time and so an abuse through
scanning is debarred.
• You can program up to 84 different channels, with an extended memory module up to the 340.
• Furthermore, it is possible to delete any transmitter channels or the complete receiver memory.
Antenna
• The receiver is already having an antenna (A), and a 8.5 cm long piece of wire at the antenna pole
connection.
• D o not modificate the length of this wire (loss of range) !
• In order to improve the reception, an antenna FK868 is optionally available.
Programming and deleting transmitters RADIO programming
Important
• For security reasons it is recommended to delete the whole memory contents of the receiver by any new instal-
lation. „D eleting the whole memory contents “, page 30 .
• To memorize or delete a transmitter you have to press certain transmitter buttons (memory button P3, channel
buttons) / receiver buttons (meomory button P1, deleting button P2). You also have to pay attention to certain
signal tones emitted by the receiver.
Antenna FK 868
(optional)
Explanation of symbols for radio programming
press the button and
keep it pressed
release the button process completed
Signal tones of the receiver
continuous tone slow tone sequence fast tone sequence
or
or