Total Control Products RCKP214, Installaton Manual

Page: 31 / 41

2
7918-007 - Hardware Kit
Qty Part Number Description
3 3100-019-32C Locknut 10-32 nylon insert
3 3104-019F0.75S Button head 10-32 x 3/4” cap screw
2 3106-38FD0.75B Set screw 3/8-24 x .75 long
3 3157-019-S-S Washer #10 stainless steel
PARTS LIST
COLM-04 - Lower Column Support 64-67 Mustang
Qty Part Number Description
1 7900-055 Column clamp 2-1/4” OD column
1 7900-139 Lower column support plate 64-67 Mustang
1 7900-167 Column firewall seal 64-67 Mustang
1 7918-007 Hardware kit
INSTRUCTIONS
NOTE: A 1965 Mustang was used for the following images and may show slight differences from the later
Mustang and Cougar platforms. The installation procedure is identical.
1. Remove the OEM lower column plate
and firewall seal.
2. Place the column support bracket
against the inside of the firewall at the
factory steering column hole.
3. Verify that the bolt pattern matches the
existing holes.
4. If the support bracket pattern matches
factory holes, remove the bracket and
use a 13/64” bit to open up the holes.
5. If support bracket pattern does not
match the factory holes, new holes will
have to be drilled through the firewall to
match the support bracket.
6. Mark the hole location with a center
punch or begin drilling hole with bracket
in place.
7. We suggest starting the holes then
removing the bracket to reduce the
chance of damaging the finish of the
bracket.