Total Control Products RCKP214, Installaton Manual

Page: 27 / 41

6
25. Use a 9/64” or .140” diameter drill bit
and drill holes into column through
bearing retainer.
26. Remove steering wheel nut, steering
wheel, steering shaft and bearing
assembly to remove metal chips from
inside of column tube. Re-install
steering shaft and bearing retainer
assembly.
27. Install upper column bearing and spring.
28. Temporarily install steering wheel and
nut.
29. The steering wheel will be removed
again to index to the front wheels.
30. Secure bearing retainer to column using
3 stainless-steel Phillips sheet metal
screws.
STEERING COLUMN INSTALLATION
31. From the vehicle interior, insert column
through hole in firewall.
32. Position steering column at original
height.
33. Install upper dash bracket.
34. Secure column floor mount assembly
over factory firewall seal using supplies
hardware.
35. Instructions for floor mount assembly
provided in COLM-04.
36. Re-connect turn signal harness.