5
16. Insert the replacement steering shaft
into the column tube.
17. Place bearing retainer assembly onto
column tube. Make sure that the retainer
seats firmly on the tube.
18. Install upper column bearing and spring.
19. Install steering wheel and steering wheel
nut. Temporarily tighten steering wheel
nut.
20. Install the external snap ring over the
steering shaft and make sure it fully
seats into the groove in the shaft.
21. Pull steering wheel towards interior of
vehicle to pull retaining ring against
bearing.
22. Steering wheel to column clearance
should be 1/16” to 3/32”.
23. If the steering wheel touches the column
while pulling, you must cut appropriate
length from end of column tube to allow
clearance.
24. If the steering wheel is greater than
3/32” from the column, 3/4” inside
diameter shims or washers can be
placed between the retaining clip and
roller bearing.
Summary of Contents for RCKP214
