T2150 Series
4-31
Installing the FL Inverter Board
To install the T2150CDS’s FL inverter board, follow the steps below and refer to figure 4-23.
1.
Connect the
microphone
and the
volume cable
to the volume board (figure 4-23).
2.
Secure the
volume board
with one
M2.5x6 screw
(figure 4-23).
3.
Connect the
FL inverter cable
and
FL cable
to
CN1
and
CN2
on the FL inverter
board (figure 4-23).
4.
Rotate the FL inverter and seat the
FL inverter board
and route the
cables
so
they will not be pinched by the display cover or other components.
5.
Secure the
FL inverter board
with
two M2.5x6 screws
(figure 4-23).
6.
Install the display mask, optional PCMCIA card, optional memory card, and
battery pack as described in 4.11, and 4.4 back through 4.2.
Summary of Contents for T2150 series
