4-14
T2150 Series
4.
Carefully lift the
keyboard
to expose the
keyboard connector
(figure 4-11).
5.
Disconnect the
keyboard cable
from the
pressure-plate connector (PJ14)
on the
system board (figure 4-11).
Figure 4-11 Removing the keyboard
Installing the Keyboard
To install the T2150 series keyboard, follow the steps below and refer to figures 4-10 and
4-11.
1.
Connect the keyboard cable to the pressure plate connector (PJ14) on the
system board (figure 4-11).
2.
Replace the keyboard. Fit notches on the back of the keyboard into corre-
sponding holes on the computer and lay the keyboard in place (figure 4-11).
3.
Insert the keyboard brace between the AccuPoint cable and the underside of
the keyboard (figure 4-10).
4.
Secure the five latches on the keyboard base (figure 4-10).
5.
Install the optional PCMCIA card, optional memory module, and battery pack
as described in sections 4.2 through 4.4.
Summary of Contents for T2150 series
