4-28
T2150 Series
4.11 Display Mask
Removing the Display Mask
To remove the T2150 series display mask, follow the steps below and refer to figure 4-22.
1.
Turn off the power. Disconnect the AC power cord and all external cables con-
nected to the T2150 series.
2.
Remove the battery pack, optional memory card, and optional PCMCIA card as
described in sections 4.2 through 4.4.
NOTE
: It is not necessary to remove the display assembly.
3.
Remove
two rubber seals
from the display hinges to expose
two screws
securing
the
display mask
(figure 4-22).
4.
Remove the
two M2.5x6 screws
that were covered by the rubber seals (figure
4-22).
5.
Carefully insert your fingers between the mask and the LCD panel and pry open
the latches. Start with the
six latches
across the top of the display mask (figure
4-22).
6.
Continue unlatching the mask along the
sides
(
four latches
on each side), at the
bottom (
three latches)
and display supports (figure 4-22). Latches at each display
support are not indicated in the illustration.
Figure 4-22 Removing the display mask
Summary of Contents for T2150 series
