T2150 Series
4-15
4.6
Hard Disk Drive and Sound Board
Removing the Hard Disk Drive and Sound Board
To remove the T2150 series hard disk drive and sound board, follow the steps below and refer
to figures 4-12 and 4-13.
1.
Turn the computer's power off. Disconnect the power cable and all external cables
connected to the T2150 series.
2.
Remove the battery pack, optional PCMCIA card, optional memory module, and
keyboard as described in sections 4.2 through 4.5.
3.
Turn the computer over and remove
four pan-head M3x6 screws
on the bottom
(figure 4-12).
Figure 4-12 Removing four screws
4.
Turn the computer back over and open the display.
5.
Disconnect the
AccuPoint cable
from
PJ13
on the system board. Press in on the
hinge at either side to remove the palm rest (figure 4-10).
6.
Remove three
M2.5x4 screws
from the
sound cable shield
and the
sound board
cover
and lift off the cover.
7.
Disconnect the
sound cable
from
PJ1,
the
microphone cable
from
PJ2,
the
speaker cable
from
PJ3
,
and the
CD-ROM cable
from
PJ6
on
the sound board.
Summary of Contents for T2150 series
