Toshiba T-Series T3300sl, Maintenance Manual

Page: 54 / 192

3-8
5. Enter the desired subtest number from the subtest menu and press
Enter
. The following
message will appear:
TEST LOOP (1:YES/2:NO) ?
Selecting
YES
increases the pass counter by one each time the test cycle ends and then
restarts the test cycle.
Selecting
NO
returns the display to the subtest menu after the test is complete.
6. Type 1 or 2 for the Test Loop prompt and press
Enter
. The following message will appear.
ERROR STOP (1:YES/2:NO) ?
Selecting
YES
stops the test program when an error is found and displays the operation guide
on the right side of the display screen as shown below.
ERROR STATUS NAME [[ HALT OPERATION ]]
1: Test End
2: Continue
3: Retry
1:
Terminates the test program execution and exits to the subtest menu.
2:
Continues the test.
3:
Restarts the test from the beginning of the test.
Selecting
NO
displays the error status, increases the error counter by one, and resumes the
test.
7. Type 1 or 2 for the Error Stop prompt and press
Enter
to execute the subtest chosen from
the subtest menu.
Table 3-1 in Section 3.3 lists the subtests available for each test on the DIAGNOSTIC TEST
MENU. Table 3-3 in Section 3.14 describes the error code and error status for each potential
error.