Toshiba SD-2300, Service Manual

Page: 90 / 160

Rear panel (2)
Screws (1)
Slider
Pickup mechanism
assembly
Tray (3)
Gear (4)
Gear (4)
Triangle mark
Triangle mark
Marking
Gear (4)
Position of the line
Fig. A
Fig. B
Tray rack gear
Fig. 2-1-5
1-1-4. Front Panel and Tray
1. Disconnect the flexible cables (2).
Note:
• The flexible cables (2) can be connected between main
and front PC boards or between main and game port
PC boards.
2. Disconnect the flexible cable (3).
3. Remove two screws (4) and remove two GND leads (5).
4. Release four claws and remove the front panel (6).
5. Pull out the tray (7).
Fig. 2-1-6
Note:
• Insert the tray (3) with the front side of the pickup
mechanism assembly descended. (The slider positions
to the left side.)
• The gears are required to match their phases each other.
After setting the gear as shown in the Fig. A, insert the
tray (3). When inserting a tray (3), push the rack gear
side shown by the arrow. (Refer to Fig. 2-1-7.)
• Confirm that the marking of the gear (4) matches with
the triangle mark on the reverse side of the tray in the
tray close status. (The gear is rotated with the slider
locks.) (Refer to Fig. B.)
Fig. 2-1-7
1-1-5. Rear Panel
1. Remove three screws (1) and remove the rear panel (2).
Fig. 2-1-8
Tray (7)
Claw
Claw
Flexible
cable (2)
Flexible
cable (2)
Flexible cable (3)
Tape (1)
Screw (4)
Screw (4)
Claws
Front
panel (6)
GND lead (5)
GND lead (5)
A
B
Tray panel (4)
Tray (3)
Tray (3)
Claws
Tray panel (4)