Toshiba IP edge EC, Installation Manual

Page: 35 / 206

EC SERVER EC Rear Panel Connections
Installation Manual August, 2011 2-3
The power supply is accessed through the rear panel. All cable
connections are on the rear panel.
Buttons Power On/Off Button - This applies or removes system power. When the
power is turned off using this button main power is shut off but standby
power to the system remains on. To completely remove power from the
system use this button to shut down the system then, disconnect the AC
power cord.
Power Up Sequence : Set the rear panel power switch to ON. Wait one
minute then, press the font panel power button.
System Reset Button - Press and release to reset then, reboot the
server.
LEDs Power LED - Indicates that system power is on when Illuminated.
Disk drive activity LED - Lights while a hard disk drive or the DVD-ROM
drive is accessed.
NIC 1 - Indicates activity on the LAN 1 connection
NIC 2 - Indicates activity on the LAN 2 connection
Both NIC connections support 10BASE-T, 100BASE-TX, and 1000BASE-
T, RJ45 output
EC Rear Panel
Connections
The rear panel connectors and indicators are described below. Refer to
Figure 2-3 .
• AC power cord connector and AC power input switch
• Keyboard and PS/2 Mouse
• USB 0 and USB 1
• COM1
• VGA
• LAN1 and LAN2
• IPMI