TOSHIBA
2 - 4
Start-Up and Test
Prior to releasing an electrical drive system for regular operation after installation,
the system should be given a start-up test by qualified personnel. This assures
correct operation of the equipment for reasons of reliable and safe performance. It is
important to make arrangements for such a check and that time is allowed for it.
When power is applied for the first time, the drive's parameters are set to the values
listed as "FACTORY SETTING" in the charts starting on page 8-1. If these settings are not
optimal for the application, program the desired settings before initiating a run. The
drive can be operated with no motor connected. Operation with no motor
connected or use with a small trial motor is recommended for initial adjustment or for
learning to adjust and operate the drive.
Maintenance
1)
Use lockout/tagout procedures in accordance with local electrical codes
before performing any drive maintenance.
2)
Periodically check the operating drive for cleanliness.
3)
Do not use liquid cleaning agents.
4)
Keep the heatsink free of dust and debris.
5)
Periodically check electrical connections for tightness (with power off,
locked out, and with charge LED out (see page 5-1 for location)).
CAUTION
CAUTION
Specifications
Precautions
Wiring
Jumpers
Panel
Keypad
Parameters
Programming
Service
Dimensions
Index
Inspection
Summary of Contents for Adjustable Speed Drive H3
Page 1: ...March 2008 Part 46687 004 ...
Page 2: ......
