20
En
gli
sh
SETTING UP YOUR TV
s
Press
b
to highlight
Start Scan
, and press
OK
.
The television will start to search for available
DTV
and/or
ATV
channels. The progress bar will
indicate the scan status.
You must allow the television to complete the
search.
When the search is complete, the television will
automatically select channel one.
The
Auto Tuning
screen will display the total
number of services found.
T
Press
C
/
c
to view the
DTV
(digital channel) or
ATV
(analogue channel) lists.
u
Press
B
/
b
to move through the list to select a
channel, and then press
OK
to view.
In
ATV
mode, some areas may receive duplicate
stations. There may not be a clear picture or the
signal may be weak, so the station order can be
changed using
ATV Manual Tuning
.
REMEMBER:
Press
TV
at any time to select
between
ATV
and
DTV
modes.
NOTE:
The time will be set automatically by
transmission but can be advanced or decreased
by using
Local Time Setting
in the
DTV Settings
screen.
v
Select
Next
and press
OK
. The
Satellite Settings
screen will appear. From this window, you can add
the satellites that you wish to tune and configure
detailed settings for each one individually.
Select
Switch Type
and choose the correct switch
configuration for your satellite dish from the
settings
None
,
ToneBurst
,
DiSEqC 2way
,
DiSEqC 4way
or
Single cable
.
NOTE:
•
None
is being used when the satellite dish will
control only one universal Low Noise Block
(LNB) with a single satellite (e.g. Astra 19.2°). As
a rule, most households use just one satellite.
•
ToneBurst
sends a 22 kHz signal.
ToneBurst
is
only necessary for simple LNBs (not universal
LNBs). The 22 kHz signal is needed for
switching LNBs with multifeed signals as well as
for changing between low- and high-band.
•
DiSEqC 2way
automatically switches between
two LNBs, which receive different satellites at the
same time (e.g. Astra 19.2° and Hotbird 13°).
•
DiSEqC 4way
automatically switches between
up to four LNBs / satellites.
•
Single cable
is selection and control of plural
Satellite antennas through the combined single
antenna cable.
The setting
LNB Power
enables you to switch on
or off the LNB's power supply by means of the TV.
When your satellite dish consists of only one LNB,
LNB Power
should generally be activated (
On
).
When using more than two LNBs, it is
recommendable to use external power supply for
these.
It is possible to select up to four satellites. Please
note that the number of available LNBs and the
adjustment of your satellite dish determines the
number of satellites found. For example, it is not
possible to receive more than one satellite if your
dish is directed to a single satellite. For further
information on satellite signal technology, please
contact your local dealer.
Auto Tuning - Antenna
Channel: 23
Progress
0
0
DTV Tune
ATV Tune
4 %
Waiting...
Found
1
Astra 19.2E
1
1
2
3
4
None
ToneBurst
DiSEqC 2way
DiSEqC 4way
Single Cable
Satellite Settings
Switch Type
LNB Power
None
On
No.
Satellite
Dish
LNB
Done
1
Astra 19.2E
1
1
2
3
4
On
Off
Satellite Settings
Switch Type
LNB Power
None
On
No.
Satellite
Dish
LNB
Done
