72
DE
EN
Setting the battery type and units of measurement (Cruise models with Tiller
only)
1
2
setup
cal.
3
NOTE!
When setting the battery bank size, note that, for example, a battery
bank with 2 serially connected batteries of 12 volts and 200 Ah each has a total
capacity of 200 Ah at 24 volts (and not 400 Ah).
1.
Switch on the system, see chapter “Switching on and off”.
2.
Press the “setup” button (1) to enter the set-up menu.
»
The unit for the remaining range is displayed.
3.
Select the desired unit with the CAL button (2) and confirm your selection
with the “setup” button.
»
The selection is saved and the menu automatically switches to the speed
indicator setting.
4.
Select the desired unit with the CAL button and confirm your selection with
the set-up button.
»
The selection is saved and the menu automatically switches to the battery
status display setting.
5.
Select the desired unit with the CAL button and confirm your selection with
the set-up button.
»
The selection is saved and the menu automatically switches to the battery
bank size setting.
6.
Set the size of the battery bank (Ah) by turning the accelerator lever of the
tiller (3) and confirm your selection with the “setup” button.
»
The selection is saved and the set-up menu is closed.
»
Settings completed.
NOTE!
The capacity display in percent and the remaining range are only possible
after the first battery calibration.
7.1.2 Enumerating the battery (Torqeedo batteries only)
2
1
setup
cal.
Only for Cruise 3.0 and 6.0 models with the following item numbers:
1260-00, 1261-00, 1262-10, 1263-10, 1264-00, 1265-00, 1266-00, 1267-00, 1268-00.
To set up communication between the battery and the outboard motor, the bat-
teries must be registered once with the system.
1.
Turn the battery main switch of your system to the “ON” position.
2.
Switch the system on to turn on the batteries.
3.
Switch off the system, taking care not to press the ON/OFF button (1) for
more than 1 second so as not to switch off the batteries again.
4.
Press the “ON/OFF” button (1) first and then the CAL button (2) in quick suc-
cession. The CAL button must be pressed while the system is booting up. In
this phase, the display shows all symbols simultaneously.
»
The components of the system connect to each other. The display shows
ENU (for enumeration), the progress in percent and the number of batteries
found.
»
Enumeration is completed when progress reaches 100%.
