71
DE
EN
the highest position.
4
3
5.
Remove the locking ring (3) of the trim rod (4).
6.
Pull out the trim rod and reposition it.
7.
Fit the locking ring of the trim rod.
8.
Tilt the motor down - to do this lift the motor and then pull the tilt lever.
Slowly lower the motor until the end position is reached.
9.
Set the tilt lock lever to the “Lock” position.
»
The trim angle of the motor is set.
7 Commissioning
7.1 Settings
7.1.1 Setting the battery type and units of measurement
The battery types and units of measurement are set via the on-board computer
on all Torqeedo systems. On Cruise models with Tiller, the settings can be made
via the on-board computer in the Tiller.
Notes on setting the battery type
When using external batteries, note that you are specifying the actual usable
capacity of your battery bank.
TIP!
If you use external batteries and a battery monitor (not included), you can
adjust the age-related capacity change of your battery bank once per season. To
do this, charge the empty battery bank to 100 %. Read the charged ampere hours
(Ah) on the battery monitor and correct the original value in the system.
NOTE!
The following setting only applies to Cruise models with Tiller. For the
setting on all other Cruise models, please refer to the operating manual for the
respective accelerator lever.
You can choose from the following units of measurement:
Range
Kilometre (km)
American miles (mi)
Nautical miles (nm)
Hours (h)
Speed
Kilometres per hour (km/h)
Miles per hour (mi/h)
Knots (kn)
Battery state of charge display (SOC)
Percent (%)
