78
79
Deutsch
English
Deutsch
English
5.3 Remote throttle control (Cruise R)/ tiller (Cruise T) with integrated display
and Magnetic Kill Switch
5.3.1 Use of battery charge display when operating with Power 26-104 battery
5.3.1.1 Establishing communication between Power 26-104 and
Cruise outboards / Enumeration
Please check whether the batteries are physically existent and have all been switched
on. Commissioning only works if the system is able to communicate with the existing
batteries.
To establish communication between battery and outboard, a one-time calibration is
necessary.
Switch the main switch of your system to the ON position.
Then push the following buttons in rapid succession: first the ON-OFF push-button un-
derneath the display (in the remote throttle control or on the peen), and right afterwards
(briefly) the CAL push-button underneath the display.
The screen will now change to ENU and display the start of the enumeration procedure.
The components establish the communication with each other automatically. The screen
will display the progress of the enumeration in percent and the number of detected bat-
teries.
After the process is completed, the progress counter shows 100% and the number of
connected batteries.
Restart the system after completion of the process by pushing the ON-OFF push-button.
Motor and battery are now communicating directly with each other. This enables you –
among others – to look up the charge state of your batteries on the display.
Please note the following: If you want to operate the Cruise with a different battery bank,
enumeration must be repeated. Otherwise, error E84 will be displayed.
Please be aware, that for older Cruise models, the communication between outboard and
Power 26-104 may not be available. Contact Torqeedo Service for questions.
Other messages:
Drive slowly: pops up when battery capacity is < 30%.
Charging: is being displayed under charging.
GPS module integrated into battery pack is searching for satellite
signals for speed determination. As long as no GPS signal is received
display in second field will always indicate “remaining range at cur-
rent speed” (indication of time) and a clock symbol will be displayed. If
remaining run-time is more than 10 hours, remaining running time will
be displayed in whole hours. If it is less, remaining running time is dis-
played in hours and minutes. GPS module stops signal searching after 5
minutes if no signal has been received. To activate search again, switch off the system on
“ON/OFF” button and then on again.
This symbol is displayed when tiller or remote throttle shall be brought into
middle position (stop position). Without doing so, starting will be impossible.
Is displayed in case of overtemperature of motor or batteries (operating with
Power 26-104). In this case, motor will decrease power independently.
Error: In case of errors, in the undermost box, “Error” symbol and an error code will be
displayed. The code will indicate the component causing the error and the error itself.
Chapter 5.3.4. describes any error codes.
In case of a drop of charge level below 30%, three beeps will be emitted (Cruise T Models
only). Signal beep is repeated in case of drop of charge level below 20% resp. 10%.
Watch the charge status while operating the motor.
