Maintaining the Headlights
Replacing the Bulbs
CAUTION
If you install a higher wattage bulb than the system
is designed for, you may damage the 12 V power
supply, or at a minimum, blow the fuse.
Always use the specified Toro LED bulb to prevent
this issue.
CAUTION
The bulbs become extremely hot when in operation.
Handling a hot bulb can cause severe burns and
personal injury.
Always all enough time to for the bulbs to cool
before replacing them. Use care whenever handling
the bulb.
Specification: See your
Parts Catalog
.
1.
Disconnect the batteries; refer to
.
2.
Open the hood; refer to
Accessing the Hood (page 29)
.
3.
Disconnect the electrical connector for the harness
from the connector of the lamp assembly at the back
of the headlight housing (
Figure 41
1.
Headlight housing
3.
Harness-electrical
connector
2.
Lamp assembly
4.
Rotate the lamp assembly 1/4 turn counterclockwise
and moving it rearward, out of the headlight housing
(
).
5.
Insert the new lamp assembly and headlight housing
and align the tabs in the lamp assembly with the slots
in the headlight housing (
).
6.
Secure lamp assembly by turning it 1/4 turn clockwise
(
).
7.
Connect the electrical connector for the harness to the
connector of the new lamp assembly (
8.
Connect the batteries and close the hood; refer to
Connecting the Batteries (page 36)
.
37
Summary of Contents for WORKMAN GTX 07131
Page 46: ...Notes...