Closing the Tailgate
If you unloaded loose material such as sand, landscaping rock,
or wood chips from the cargo box of the machine, some
of the material that you unloaded may have lodged in the
hinge area of the tailgate. Perform the following steps before
closing the tailgate.
1.
Remove as much of the material from the hinge area
as possible.
2.
Rotate the tailgate to approximately the 45° position
(
).
Figure 14
1.
Rotate the tailgate back
and forth several times.
3.
Hinge area
2.
Rotate the tailgate to
approximately the 45°
position.
3.
Use a short, shaking motion to rotate the tailgate back
and forth several times (
Note:
This action helps move material away from
the hinge area.
4.
Lower the tailgate and check for material remaining in
the hinge area.
5.
Repeat steps
through
until the material is removed
from the hinge area.
6.
Rotate the tailgate up and lift the tailgate into the
notches in the cargo box.
Using the Rear
Cargo-Box-Accessory Mount
Use the rear cargo-box-accessory mount to attach accessories
to the rear of the machine.
Capacity:
45 kg (100 lb)
1.
Loosen the ‘T’ handle by rotating it clockwise (
Figure 15
1.
Receiver
2.
‘T’ handle
2.
Insert your accessory into the receiver until the
accessory reaches the end of the receiver (
3.
Tighten the ‘T’ handle by rotating it counterclockwise
(
).
Figure 16
1.
‘T’ handle
20
Summary of Contents for WORKMAN GTX 07131
Page 46: ...Notes...