Toro WORKMAN GTX 07131, Operator'S Manual

Page: 11 / 48

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
Steering wheel 1
Cover 1
1
Washer (1/2 inch) 1
Install the steering wheel (TC Models
only).
2
No parts required
–
Check the fluid levels and tire pressure.
Operator's Manual 1
Parts Catalog 1
Safety training material 1
Registration Card 1
Predelivery Inspection Form 1
Certificate of Quality 1
Key 2
3
Charger cord
1
Read the Operator's Manual and view
the training material before operating
the machine.
Note:
Determine the left and right sides of the machine
from the normal operating position.
1
Installing the Steering Wheel
Parts needed for this procedure:
1 Steering wheel
1 Cover
1 Washer (1/2 inch)
Procedure
1. If the cover is installed, remove it from the hub of the
steering wheel (
Figure 3 ).
2. Remove the locknut (1/2 inch) from the steering shaft
(
Figure 3 ).
3. Slide the steering wheel and washer (1/2 inch) onto the
steering shaft (
Figure 3 ).
4. Secure the steering wheel to the shaft with the locknut
(1/2 inch) and tighten it to 27 to 34 N·m (20 to 25
ft-lb).
5. Install the cover on the steering wheel ( Figure 3 ).
Figure 3
1. Cover 4. Steering wheel
2. Locknut (1/2 inch) 5. Steering shaft
3. Washer (1/2 inch)
11