G018358
1
3
5
6
7
8
8
7
8
2
4
Figure 4
Side Bumper and Bracket Installation
1.
Left side bumper
5.
Right side bumper
2.
Center engine guard
6.
Right frame-support
bracket
3.
Left frame-support bracket
7.
Carriage bolt (3/8 x 1-1/4
inches)
4.
Muffler shield
8.
Flange nut (3/8 inch)
B.
Remove the left bumper and muffler shield from
the machine.
Note:
Retain the muffler shield for installation
with the new left side bumper.
C.
Remove the nuts and bolts securing the right side
bumper to the chassis and center engine guard.
Note:
Discard the carriage bolts and flange nuts
that secure the original left and right side bumpers
to the machine.
2.
Install the new left side bumper as follows:
A.
Align the new left side bumper with the
forward-mounting point on the chassis and the
bumper-mounting points on the center engine
guard (
B.
Align the mounting flange (the flange with 2
holes) of the left frame-support bracket to the left
as shown in
.
C.
Align the holes of the left frame-support bracket
and the back holes of the left side bumper with
the holes in the center engine guard (
).
D.
Loosely secure the bracket and bumper to the
center engine guard at the lower hole with a
carriage bolt (3/8 x 1-1/4 inches) and a flange nut
(3/8 inch) (
E.
Position the muffler heat shield with the mounting
flanges inside the left side bumper (
F.
Align the holes for the left frame- support bracket,
left side bumper and muffler guard to the upper
hole in the center engine guard (
G.
Loosely secure the bracket, bumper and muffler
guard to the center engine guard at the upper hole
with a carriage bolts (3/8 x 1-1/4 inches) and a
flange nut (3/8 inch) (
H.
Align the front holes in the left side bumper and
the muffler guard with the forward-mounting
point on the chassis. (
I.
Secure the bumper and guard to the mounting
point with a carriage bolt (3/8 x 1-1/4 inches) and
a flange nut (3/8 inch) (
J.
Tighten the hardware that secures the bracket,
bumper and muffler guard to the center engine
guard.
3.
Install the new right side bumper as follows:
A.
Align the new right side bumper with the
forward-mounting point on the chassis and the
bumper-mounting points on the center engine
guard (
B.
Align the mounting flange (the flange with 2
holes) of the right frame-support bracket to the
left as shown in
.
C.
Align the holes of the right frame-support bracket
and back holes of the right side bumper with the
back, center engine guard (
).
D.
Loosely secure the bracket and bumper to the
center engine guard with 2 carriage bolts (3/8 x
1-1/4 inches) and 2 flange nut (3/8 inch) (
).
E.
Align the front hole in the new right side bumper
with the forward mounting point on the chassis
(
).
F.
Secure the bumper to the mounting point with
a carriage bolt (3/8 x 1-1/4 inches) and a flange
nut (3/8 inch) (
).
G.
Tighten the hardware that secures the bracket and
bumper to the center engine guard.
7
