5
G018442
3
4
1
2
3
Figure 30
Tape Marking the Aligned Holes
1.
Upper discharge tube
4.
Hole (1/4 inch)
2.
Lower discharge tube
5.
Screw (1/4 x 3/4 inches)
3.
Tape (marker)
F.
Rotate the upper tube so that the end in the hood
points towards the center of the hood (
).
Note:
The parting lines on the tube will be
approximately horizontal at the hood seal (
4
4
5
G01861 1
1
2
3
Figure 31
Upper Discharge Tube and Bagger Hood
1.
Lower discharge tube
4.
Parting line
2.
Upper discharge tube
5.
Projecting end of upper
discharge tube
3.
Bagger hood
G.
While maintaining the approximate position of
the upper discharge tube, align the holes in the
upper and lower duct (
H.
Insert a screw (1/4 x 3/4 inch) through one of the
holes to maintain the alignment of the upper and
lower tubes (
).
I.
Mark each tube on the area adjacent to the screw
with a piece of tape (
Note:
Accomplish measurement and marking
the upper discharge tube with the hood closed
and accessed from beneath the hood.
J.
With the deck in the lowest position and the hood
closed, look underneath the hood and measure
the length of the upper discharge tube protruding
into the hopper. If the discharge tube extends
more than 7.6 cm (3 inches), remove the excess
tube length (
22
