Toro 41188, Service Manual

Page: 262 / 353

Multi Pro 1750 Page 7 − 36 Drive Train
Transaxle Assembly
1. Clean gasket material from all transaxle mating sur-
faces before assembling transaxle. Make sure all parts
are clean and free of dirt and dust.
IMPORTANT: Be careful to not damage mating sur-
faces when removing gasket material.
2. Assemble L.H. axle shaft:
A. Install new oil seal into differential carrier.
B. Use a press to install bearing onto L.H. axle shaft.
C. Install washer and snap ring.
D. Install L.H. axle shaft assembly into differential
carrier.
E. Install snap ring.
F. Install new O−ring. Apply multi−purpose grease
on O−ring before installing.
L.H. AXLE SHAFT
2
3
6
8
1
5
7
4
1. O−ring
2. Snap
ring
3. L.H. axle shaft assembly
4. Snap
ring
5. Washer
6. Bearing
7. Oil
seal
8. Differential carrier
Figure 55
3. Assemble R.H. axle shaft:
A. Install new oil seal into seal cover. Apply multi−
purpose grease on O−ring before installing.
B. Insert washer.
C. Use a press to install bearing onto R.H. axle shaft.
D. Install washer and snap ring.
E. Install R.H. axle shaft assembly into seal cover.
R.H. AXLE SHAFT
2
3
6
1
5
4
7
Figure 56
1. R.H. axle shaft assembly
2. Snap
ring
3. Washer
4. Bearing
5. Oil seal
6. Washer
7. Seal
cover
4. Assemble differential lock fork shaft:
A. Drive lock pins into fork shaft. Make sure lock pins
are installed with slit facing the correct direction.
B. Install fork, spring, washer and snap ring onto
fork shaft using a press. Apply moly disulfide grease
onto fork portion of fork shaft before installing.
C. Install new O−ring. Apply multi−purpose grease
on O−ring before installing.
1. O−ring
2. Snap
ring
3. Washer
4. Spring
5. Fork
6. Roll pin
7. Roll pin
8. Washer
9. Fork
shaft
Figure 57
6
5
4
3 2
1
7
8
9