Right Joystick—Mode II
Note:
The joystick controls vary depending on the control
mode you select when powering up the machine. There
are 2 control modes: Mode I and Mode II; refer to the
Control-select Screen (page 25)
for information on setting
the control mode.
g021833
5
6
7
8
9
4
2
3
1
Figure 42
1.
Joystick—move left
6.
Front button
2.
Joystick—move forward
7.
Rear button
3.
Joystick—move rearward
8.
Lower button
4.
Joystick—move right
9.
Trigger
5.
Toggle switch
Toggle Switch
Rock the switch forward to increase the flow rate of the
drilling fluid; rock the switch rearward to decrease the flow
rate of the drilling fluid.
Note:
Before using this feature you must first turn on
the drilling-fluid pump using the lower button on the right
joystick.
Front Button
Press this button to apply thread-joint compound.
Rear Button
Press and hold this button for maximum drilling fluid
pressure; use this to quickly fill the pipe with drilling fluid
after adding or removing a pipe. Release the button to stop
the flow or return to the previously set flow rate.
Lower Button
Press this button to turn the drilling-fluid pump on or off.
Trigger
Press and hold the trigger to move the drill carriage at high
speed up or down the drill frame.
Joystick—Forward
Push the joystick forward to thrust the drill carriage forward.
Joystick—Rearward
Pull the joystick rearward to pull the drill carriage rearward.
Joystick—Left
•
Left trigger pressed—opens the lower wrench (stationary
wrench).
•
Left trigger released—raises the pipe elevator.
Joystick—Right
•
Left trigger pressed—closes the lower wrench (stationary
wrench).
•
Left trigger released—lowers the pipe elevator.
40
