After Operation
After Operation Safety
General Safety
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn, damaged, or missing decals.
Transporting the Machine
•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use full-width ramps for loading the machine into
a trailer or a truck.
•
Tie the machine down securely.
Refer to
and
for the tie-down
locations on the machine.
Note:
Load the machine on the trailer with the front
of the machine facing forward. If that is not possible,
secure the machine hood to the frame with a strap,
or remove the hood and transport and secure it
separately; otherwise, the hood may blow off during
transport.
g009820
Figure 19
1.
Eye hole in the frame (each side)
g009821
Figure 20
1.
Axle
2.
Hitch plate
Towing the Machine
In case of an emergency, you can tow the machine
for a short distance; however, this is not the standard
operating procedure.
WARNING
Towing at excessive speeds could cause a
loss of steering control, resulting in personal
injury.
Never tow the machine at faster than 8 km/h
(5 mph).
Note:
The power steering does not function,
making it difficult to steer.
Towing the machine is a 2-person job. If you must
move the machine a considerable distance, transport
it on a truck or trailer.
1.
Affix a tow line to the tongue at the front of the
frame of the machine (
2.
Move the transmission to the N
EUTRAL
position
and disengage the parking brake.
29
Summary of Contents for 07385TC Workman HDX-D
Page 39: ...g010359 Figure 32 39...
