Toro 07385TC Workman HDX-D, Original Instructions Manual

Page: 35 / 64

Removing the Full Bed
1. Start the engine, engage the hydraulic-lift lever,
and lower the bed until the cylinders are loose
in the slots.
2. Release the lift lever and shut off the engine.
3. Remove the lynch pins from the outer ends of
the cylinder rod clevis pins (
Figure 23 ).
g002368
Figure 23
1. Cylinder rod end 4. Lynch pin
2. Bed-mounting plate 5. Rear slots (full bed)
3. Clevis pin 6. Front slots (2/3 full bed)
4. Remove the clevis pins securing the cylinder rod
ends to the bed-mounting plates by pushing the
pins toward the inside (
Figure 23 ).
5. Remove the lynch pins and clevis pins securing
the pivot brackets to the frame channels (
Figure
23 ).
6. Lift the bed off the machine.
CAUTION
The full bed weighs approximately 148 kg
(325 lb), so do not try to install or remove
it by yourself.
Use an overhead hoist or get the help of
2 or 3 other people.
7. Store the cylinders in the storage clips.
8. Engage the hydraulic lift-lock lever on the
machine to prevent accidental extension of the
lift cylinders.
Installing the Full Bed
Note:
If you are installing the bed sides on the flat
bed, it is easier to install them before installing the
bed on the machine.
Ensure that the rear pivot plates are bolted to the bed
frame/channel so that the lower end angles to the rear
(
Figure 24 ).
g002369
Figure 24
1. Left, rear corner of bed 4. Clevis pin
2. Machine frame channel 5. Lynch pin
3. Pivot plate
CAUTION
The full bed weighs approximately 148 kg
(325 lb), so do not try to install or remove it
by yourself.
Use an overhead hoist or get the help of 2 or 3
other people.
Ensure that the spacer brackets and wear blocks
(
Figure 25 ) are installed with the carriage-bolt heads
positioned inside the machine.
35