Toro 07385TC Workman HDX-D, Original Instructions Manual

Page: 25 / 64

g026141
Figure 16
1. Latch handle 3. Latch pin
2. Latch gate
Starting the Engine
1. Sit on the operator’s seat and engage the
parking brake.
2. Disengage the PTO and high-flow hydraulics (if
equipped) and move the hand-throttle lever to
the O
FF
position (if equipped).
3. Move the shift lever to the N
EUTRAL
position and
press the clutch pedal.
4. Ensure that the hydraulic-lift lever is in the center
position.
5. Keep your foot off the accelerator pedal.
6. Rotate the key switch to the O
N
position.
Note:
When the glow-plug-indicator light turns
on, the engine is ready to start.
7. Rotate the key switch to the S
TART
position.
Note:
Release the key immediately when the
engine starts and allow it to return to the R
UN
position.
Note:
The glow-plug indicator turns on for an
additional 15 seconds when the switch returns to the
R
UN
position.
Note:
Do not run the starter motor more than 10
seconds at a time or premature starter failure may
result. If engine fails to start after 10 seconds, turn
the key to the O
FF
position. Check the controls and
starting procedure, wait 10 additional seconds, and
repeat the starting operation.
Engaging the 4-Wheel Drive
4-Wheel Drive Models Only
To enable automatic 4-Wheel Drive, press the top of
the rocker switch into the 4
X
4 A
UTO
position ( Figure
17 ).
g227244
Figure 17
1. 4x4 auto enable—on
2. 4x4 auto enable—off
When the 4WD switch is on, the machine automatically
engages the 4-wheel drive if the sensor detects the
back wheels spinning freely. When the 4-wheel drive
is engaged, the 4WD switch light turns on.
Important:
When in reverse, the machine does
not automatically engage the 4-wheel drive.
In reverse, you must manually engage the 4-wheel
drive using the 4WD button.
To engage the 4-wheel drive manually, press and
hold the 4WD button on the center console while the
vehicle is in motion and the 4-wheel drive engages.
Note:
The 4-wheel drive remains engaged only as
long as you hold the button; the 4WD switch does not
need to be in the A
UTO
position to manually engage
the 4-wheel drive.
25