Toro 07385TC Workman HDX-D, Original Instructions Manual

Page: 17 / 64

Coolant-Temperature Gauge and
Light
The coolant-temperature gauge and light registers the
coolant temperature in the engine and operates only
when the key switch is in O
N
position ( Figure 5 ). The
indicator light blinks red if the engine overheats.
Charge Indicator
The charge indicator illuminates when the battery
discharges. If the light illuminates during operation,
stop the machine, shut off the engine, and check for
possible causes, such as the alternator belt (
Figure 5 ).
Important:
If the alternator belt is loose or
broken, do not operate the machine until the
adjustment or repair is complete. Failure to
observe this precaution may damage the engine.
Check the operation of the warning lights as follows:
•
Engage the parking brake.
•
Turn the key switch to the O
N
/P
REHEAT
position,
but do not start the engine. The coolant
temperature, charge indicator, and oil-pressure
lights should glow. If any light does not function,
either a bulb is burned out or there is a malfunction
in the system that you must repair.
Fuel Gauge
The fuel gauge shows the amount of fuel in the tank.
It displays only when key switch is in the O
N
position
( Figure 5 ). The red segment of the display indicates a
low-fuel level and the flashing red light indicates that
the fuel in the tank is near empty.
4-Wheel Drive Switch
4-Wheel Drive Models Only
When the 4WD switch ( Figure 5 ) is on, the machine
automatically engages the 4-wheel drive if the sensor
detects the back wheels spinning freely. When the
4-wheel drive is engaged, the 4WD switch light turns
on.
High-Flow Hydraulics Switch
TC Models Only
Turn on the switch to activate the high-flow hydraulics
(
Figure 5 ).
Horn Button
TC Models Only
Pressing the horn button activates the horn ( Figure 5 ).
Press the horn button to sound the horn.
Tachometer
The tachometer displays the speed of the engine
(
Figure 5 and Figure 9 ).
Note:
The white triangle indicates the desired engine
speed for 540 rpm PTO operation.
g010514
Figure 9
1. Engine speed (rpm) 2. 3,300 rpm for 540 rpm
PTO operation
Speedometer
The speedometer registers the ground speed of the
machine (
Figure 5 ). The speedometer is in mph, but
you can easily convert it to km/h; refer to Converting
the Speedometer (page 55) .
Power Point
Use the power point ( Figure 5 ) to power optional 12
V electrical accessories.
17