Toro 07385TC Workman HDX-D, Original Instructions Manual

Page: 40 / 64

Engine Maintenance
Engine Safety
•
Shut off the engine, remove the key, and wait for
all moving parts to stop before checking the oil or
adding oil to the crankcase.
•
Keep your hands, feet, face, clothing, and other
body parts away from the muffler and other hot
surfaces.
Servicing the Air Cleaner
Service Interval: Every 25 hours—Remove the
air-cleaner cover and clean out the
debris.
Every 100 hours—Change the air-cleaner filter
(more frequently in dusty or dirty conditions).
Inspect the air cleaner and hoses periodically to
maintain maximum engine protection and to ensure
maximum service life. Check the air-cleaner body
for damage that could possibly cause an air leak.
Replace a damaged air-cleaner body.
1. Release the latches on the air cleaner and pull
the air-cleaner cover off the air-cleaner body
(
Figure 33 ).
g002401
Figure 33
1. Air-cleaner cover 2. Filter
2. Squeeze the dust cap sides to open it and knock
the dust out.
3. Gently slide the filter out of the air-cleaner body
(
Figure 33 ).
Note:
Avoid knocking the filter into the side of
the body.
Note:
Do not attempt to clean the filter.
4. Inspect the new filter for damage by looking
into the filter while shining a bright light on the
outside of the filter.
Note:
Holes in the filter appear as bright
spots. Inspect the element for tears, an oily
film, or damage to the rubber seal. If the filter is
damaged, do not use it.
Note:
To prevent engine damage, always
operate the engine with the air filter and cover
installed.
5. Carefully slide the filter over the body tube
(
Figure 33 ).
Note:
Ensure that it is fully seated by pushing
on the outer rim of the filter while installing it.
6. Install the air-cleaner cover with the side facing
up, and secure the latches (
Figure 33 ).
40