Product Overview
Controls
Become familiar with all the controls before you start
the engine and operate the machine.
Note:
Determine the left and right sides of the
machine from the normal operating position.
Control Panel
g240582
Figure 5
1.
Light switch
9.
Key switch
2.
High-flow hydraulics
switch (TC models only)
10.
Power point
3.
Horn (TC models only)
11.
Third high lockout switch
4.
Tachometer
12.
Oil-pressure-warning light
5.
Hour meter
13.
Glow-plug indicator
6.
Speedometer
14.
Charge indicator
7.
Coolant-temperature
gauge and light
15.
4-wheel drive switch
(4-wheel drive models
only)
8.
Fuel gauge
Accelerator Pedal
Use the accelerator pedal (
) to vary the ground
speed of the machine when the transmission is in
gear. Pressing down the accelerator pedal increases
the engine speed and ground speed. Releasing the
pedal decreases the engine speed and ground speed.
g036549
Figure 6
1.
Clutch pedal
3.
Accelerator pedal
2.
Brake pedal
Clutch Pedal
You must fully press the clutch pedal (
to disengage the clutch when starting the engine
or shifting transmission gears. Release the pedal
smoothly when the transmission is in gear to prevent
unnecessary wear on the transmission and other
related parts.
Important:
Do not ride the clutch pedal during
operation. The clutch pedal must be fully out or
the clutch slips, causing heat and wear. Never
hold the machine stopped on a hill using the
clutch pedal. Damage to the clutch may occur.
Brake Pedal
Use the brake pedal to stop or slow the machine
(
CAUTION
Operating a machine with worn or incorrectly
adjusted brakes can may result in personal
injury.
If the brake pedal travels to within 25 mm (1
inch) of the machine floor board, adjust or
repair the brakes.
14
Summary of Contents for 07385TC Workman HDX-D
Page 39: ...g010359 Figure 32 39...
