7
Installation Steps and Start
-
Up Procedures
Warning: Installation of this appliance must conform with state and local plumbing codes,
laws, regulations, and the instructions provided with this appliance. Failure to install as in-
structed will void the product warranty.
Pre
-
Installation Checklist
•
Look under sink to identify where the unit will rest.
•
To identify hot from cold, turn on hot water at the sink until hot water is flowing. Touch
pipes below and mark cold from hot.
•
Identify desired location for new faucet and mark sink for drilled hole, unless hole is pre
-
existing.
•
Review tool kit supplies needed (Table 1).
•
Open box and confirm 3 filter cartridges (PRE, POST & RO), 1 RO unit (tank & manifold)
and installation kit (if purchased
*
).
* If installation kit is not purchased, you will need:
3
—
4’
x
1/4”
tubing
1
—
3/8”
drain saddle (sized for air
-
gap or non air
-
gap)
1
—
3/8”
tubing if air
-
gap is desired
1
—
Feed water adapter
1
—
1/4”
WOW RO emergency shut
-
off valve
1
—
Faucet with appropriate connector to
1/4”
tubing
Step 1
Recommended Tool List
Professional Installers
“
Must Have
”
Tool List
Relton drill
1
-
1/4”
assembly (HST
-
20)
(porcelain sinks)
2 pressure gauges adapted to
1/4”
tube
Greenlee
1/2”
to
1
-
1/4”
punch
(stainless steel sinks)
Conductivity or TDS meter
1”
to
1
-
1/4”
Carbide drill bit or hole saw
Tubing cutter or sharp knife
7/16”
open
-
end wrench
1/2”
open
-
end wrench
9/16”
open
-
end wrench
5/8”
open
-
end wrench
Medium
-
sized (#2) Phillips screwdriver
Table 1:
Recommended Tool List
Summary of Contents for WOW RO System
