Topper WOW RO System, Installation & User Manual

Page: 18 / 39

18
Adding a Coffee Maker
Commercial Coffee Maker Hook - ups: (Figure 8A, Page 21)
Adding a line from the WOW RO System to a commercial coffee maker
will ensure RO water is always being used to create great tasting coffee
and reducing or eliminating scaling.
Adding a coffee maker hook - up from a new WOW (dry) installation:
a. Remove the 3/8” plug from the FA1 port by pushing on the white
collet, releasing the plug.
b. Connect the 3/8” plastic tubing to the FA1 port that goes to the coffee
maker.
c. Make sure that a 3/8” isolation/shut - off valve is installed at the system
in the coffee maker line and easily accessible under the sink cabinet
(Figure 6).
d. Close isolation valve.
e. Go to Start - up Procedures (Page 13) and proceed until fully operational.
f. After start - up, open isolation valve and bleed line to coffee maker as described below
(Bleeding Lines).
Adding a coffee maker hook - up from a pre - installed WOW (wet) installation:
a. Close feed water valve.
b. Open faucet to relieve pressure on the FA ports.
c. Remove the 3/8” plug from the FA1 port by pushing on the white collet, releasing the plug.
d. Connect the 3/8” plastic tubing to the FA1 port that goes to the coffee.
e. Make sure that a 3/8” isolation/shut - off valve is
installed at the system in the coffee maker line
and easily accessible under the sink cabinet
(Figure 6).
f. Close isolation valve.
g. Turn on feed water.
h. Open isolation valve.
i. Bleed line to coffee maker as described below
(Bleeding Lines).
Bleeding Lines:
Brew a pot of coffee.
Figure 6
Isolation (shut - off) Valve