Topcon HiPer Ga, Operator'S Manual

Page: 79 / 162

MINTER Configuration
P/N 7010-0816
3-23
Data Recording Auto-start parameter
These radio buttons allow
you to program your receiver’s behavior in the event of a power
failure.
Table 3-6 describes the different scenarios available and the results
after power is restored to the receiver. “Specified file” refers to the file
name entered in the
Always append to file field.
Also, if Always is enabled, the receiver automatically logs data (to a
newly created or an existing file) in the following three cases:
• After turning on the receiver using the Power button.
• After resetting the receiver (using PC-CDU).
Table 3-6. Data Recording Parameter Behavior
Before
Power
Failure
Enabled Radio Button Results
Off On Always
Receiver data
logged to file
specified. Data logging
does not resume
when power is
restored. Receiver resumes
data logging to the
same file when
power is restored. Receiver resumes
data logging to the
same file when power
is restored.
Receiver data
logged to
default file. Data logging
does not resume
when power is
restored. A new log file
opens when power
is restored and
data logs to this
file. A new log file opens
when power is
restored and data logs
to this file.
File specified;
receiver data
logging not
started. File will not open
with this name.
Data logging
does not start
when power is
restored.
File will not open
with this name.
Data logging does
not start when
power is restored.
A log file with this
name opens and data
logging starts after
power is restored.
No file
specified;
receiver data
logging off. Data logging will
not start when
power is restored. Data logging will
not start when
power is restored. A log file with a
default name opens
and data logging
starts after power is
restored.