Toolots ZF-A5645, Manual

Page: 32 / 51

ZF-A5645-MANUAL
2, Everyday before working, you must use the air pressure blowing the
conveyor to keep it clean.
3, When there is film stick to the sealing knife, please use a cotton towel gently
remove the film (when the knife still warm). Prohibit the use of metal for
scrubbing, because the metal friction will damage the protective film on the
knife, loss the sealing knife function.
4, Scrap winding part maintenance:
(1) Maintenance once a month.
(2) Remove the fix nut and remove the spring and the collection wheel.
(3) Apply butter to the contact surface of the shaft and the winding wheel to
keep the collection wheel running smoothly.
(4) Install back the collection wheel and spring and fix back the nut.
5, chain and sprocket maintenance: about once every three months maintenance,
first remove the shield, then apply butter to the chain and sprocket. Install the
cover after maintenance.
6, bearing and bearing block maintenance: about once every 3 months, the
machine parts which are equipped with bearing and bearing block should
apply hydraulic oil to the contact gap between the spindle and bearing, to
keep the lubrication.
7, check if the cutter fixed screw is locked, if loose, please lock tight. (Once a
month)
8, after a period of running, the machine belt will be loose slightly. When the belt
can not be driven tightly, please adjust the belt tightness.
9, if the Teflon on the knife come off , which will make the film easily attach to the
knife, the knife must be re-Teflon treatment or change the new seal knife.
10, check the Teflon tape cover on the sealing silicone strip, if it
’
s damaged,