Toolots ZF-A5645, Manual

Page: 18 / 51

ZF-A5645-MANUAL
Figure5.6
B. After threading the shrink film to the rollers, then lead to the upper and lower
triangular plate. The upper and lower triangular plates are shown in Figure 5.6.
C. Finally, pull the shrink film to the middle of clamp-roller and pull-material -belt
to clamp it.
(10) When the temperature reaches the default degree, press the manual feeding
film switch ( ) once, then the pull device will pull the shrink film, if the
film is not pulled, please check the film is placed correctly or not.
(11) If the above action is normal, press the manual sealing switch ( ) once, at
that time the sealing knife will carry out the sealing action, and complete
the sealing and cutting of the shrink film.
(12) Repeat the operation several times as described in (10, 11), until the shrink
film scrap can coiled on the scrap-winding roller for 2-3 turns, then the
sealing machine can be operated automatically.
(13) Switch the machine to automatic mode (press STARTUP key) and place the
product to be packed on the conveyor.
Note: Both hands should be completely away from the conveyor surface to avoid
Upper Triangular
plate
Lower Triangular
plate
Upper Triangular plate
Lower Triangular
plate
Two layers of film