Toolots ZF-A5645, Manual

Page: 37 / 51

ZF-A5645-MANUAL
Scraps attached on the knife, or
knife broken
Clean the scraps or replace knife
12
Scraps pull film
keep working
转
Electric eyes didn
’
t line-up or
broken
Loose the eye
’
s screws and make it
line-up. until the eye light up and then
tight the screws. Or replace the electric
eye.
13
Side knife press
on pack product
The product was not driven by
the conveyor guide edge.
Place the product to the guide edge
correctly.
14
Front knife press
on the pack
product
Delay sealing time not enough,
the machine start sealing when
the product still not completely
through the seal seat.
Increase the time of seal timer
Pack product is transparent or
has gap
Refer to view compensation operation
15
Front conveyor
deviation run
The front driving roller
unstable Adjust the driving roller till the
conveyor running normally.
16
Pull film not
smooth
Wrong placement of film Adjust the position, refer to 5.1
17
Pull film
doesn
’
t run
Scraps run into the pull roller Clean scraps
18
Film upper or
down layer offset
Balancing pole wrongly adjusted Adjust balancing pole
Wrong stability of the film Replace film
19
Scraps winding
roller too tight or
too loose
Springs on the winding roller too
tight or too loose
Adjust the outside screw of the winding
roller spring.