4
、
Instruction Manual
42
1.
To check the position of the Steel Brush(refer to 4.4 chapter).
2.
To check the gearbox oil and hydraulic oil(refer to 4.5 and 4.6 chapter).
3.
To check the Altimeter of cooling water,if it andicate the cooling water is not
enough,you
Asked to add cooling water.
4.
To check and confirm the relative position between the Band saw,Active
Wheel,Passive Wheel and Block-Oriented is right.
5.
To check the Band saw Tension Wrench,and confirm the band saw has been tensioned.
6.
To check the Tension of belt between the gearbox and motor.