DVR User Manual
28
Step 6: Enter into alarm tab to select the options to handle alarm.
Buzzer
: If selected, the local inbuilt buzzer would be activated on an alarm.
Full screen alarm:
If selected, there will pop up the chosen channel
on the monitor on an alarm trigger.
To alarm out:
If selected, this would trigger the external relay output
on detecting a sensor based alarm.
Email:
If you select this option, the DVR will send an email alert to
the preconfigured email address in case of a sensor based alarm
from the particular input.
Snap:
If selected, the system will snap images of the checked
channels on an alarm and save them in the HDD automatically.
Step 7
:
Enter into To Record tab. Select recoding channels. It would
be recorded in case of an alarm. Click OK button to save the setting.
Step 8: Enter into To PTZ tab. Set preset, cruise and track options for Fig 4-22 Sensor-Schedule
a PTZ in case of a sensor based alarm. Single or multiple PTZ units could be programmed to perform this function on the same
alarm.
Step9: Enter into Schedule tab. Refer to Fig 4-22. The setup steps for schedule for sensor based alarm are similar to normal
schedule setup. You can refer to Chapter 4.4.1 Schedule for more
details. This step is very important for sensor alarm. Even if you have
enabled the sensor alarm for all channels and setup the trigger, you will
not see the result of sensor alarm if no schedule is added.
If you have set the schedule for senor based recording in the same
timeline, recordings can also be triggered.
4.5.2 Motion
Motion includes two sub menus: motion and schedule.
The steps to set up motion alarm are as follows: Fig 4-23 Alarm Configuration-Motion
