
Use and Maintenance Handbook
– Prime 400 Packaging Machine
Page 59 of 71
11.5.2 Machine switch-off
At the end of the day, or at the end of the production, the operator must:
1. Press the STOP BUTTON placed on the TOUCH PANEL in order to interrupt
the working cycle (the STOP BUTTON will stop the cycle even if the jaws are
in closing positions).
2. Wait until the end of the cycle and press the emergency button;
3. Rotate in POSITION (0) THE GENERAL SWITCH placed on the electrical
cabinet of the machine.
4. It is advisable to accurately clean the machine at the end of a working cycle.
5. It is also possible to stop the functioning cycle by acting on the emergency
button placed on the machine.
6. For the resumption of the correct working cycle of the machine act as
previously described.
11.5.3 Reset after emergency stop
Following an emergency stop (ex: jamming of the packaging film), before
resuming the normal production cycle, you need to follow the following procedure:
1. Eliminate the cause that caused the operator to act on the emergency button;
2. If you removed the protections on the machine, restore them in the right
place;
3. Unlock the button by rotating it in the way indicated by the arrow till the auto
retention device is released (if the button has been pressed);
4. Press the RESET BUTTON placed on the COMMAND AND CONTROL
PANEL to reinsert the electrical auxiliaries of the Machine and restart the
working cycle (the blue light signal switches off);
5. After have pressed the RESET BUTTON wait 10 seconds;
6. If the emergency button has been pressed with jaws in closing position, open
the jaws in JOG mode (approx. 50 mm).
7. Select MANUAL mode and the machine will perform the HOMING;
8. Press the START BUTTON placed on the COMMAND AND CONTROL
PANEL to restart a working cycle.