Timespace X300 Mark 2, Instruction Manual

Page: 33 / 185

X300 Instruction Manual Chapter 3 - User Guide – X300 Menu System
22
AUDIO VOR
-
Voice Operated Recording. If the detected level of audio input reaches a
certain percentage (25%, 50%, 75%) the alarm output can be triggered
(using ALARM OUTPUT
3 ). If using this trigger as an alarm input , a wire
link will need to be in place on the X300 rear panel (see Figure 12 - X300
Mark 2 Rear Panel - Connections for wiring pinout).
If the VOR output is being used as an alarm input to trigger recording, it
can only be used to trigger ALARM recording mode. Example setup of
VOR;
1. ALARM OUTPUT: ALM, CLOSED, AUDIO VOR 75%
2. ALARM INPUT: LD1, CLOSED, FUNCTION – ALARM REC, CAMS 1
The above example assumes that there is a wire link on the green block
between ALARM OUT and ALARM IN1. The POST TRIGGER time can also
be set to record for x seconds after the audio trigger has finished.
MOTION DETECTED - Motion is detected
GPS SPEED ALARM -
GPS has detected speed above a certain designated threshold. Configure
this in the
GPS menu.
CURRENT STATE – Describes how each alarm output is CLOSED (highlighted white) or OPEN (no
highlight) (CLOSED showing alarm terminals are connected; OPEN showing alarm terminals are not
connected).