Timespace X300 Mark 2, Instruction Manual

Page: 146 / 185

X300 Instruction Manual Chapter 6 - Installation Guide
135
Mounting Hole Location
The mounting holes must be drilled on 126mm and 88mm centres (see Figure 16 - X300 Mark 2
Mechanical Data).
Installation Procedure
It is advised that some form of thread-lock compound should be used on the screws securing the
wire rope mounts to both the X300 and mounting surface. This is in order to prevent loosening due
to vibration. WARNING - Ensure only a small amount of adhesive is added to the screw points.
Excessive amounts will leak onto the circuit board and damage components.
Attach the Wire Rope Mounts to the X300 with four of the countersunk M4 hex-head screws
provided and L-shaped hex key. When attaching the rear pair of mounts please ensure that the
stabilizer is ‘sandwiched’ between the mounts and the X300 by aligning the stabilizer holes with the
mounting holes in the X300.
Please note that the ‘open’ end of the C-shaped plastic stabiliser should be attached to the rear wire
rope mounts and face backward – see Figure 19 - Wire Rope Mounts below.
Once all of the Wire Rope Mounts have been securely attached to the X300, use a pair of
countersunk M4 hex-head screws to attach the bottom ‘feet’ of the front Wire Rope Mounts to the
mounting surface/enclosure.
Secure the lower ‘feet’ of the rear Wire Rope Mounts to the mounting surface/enclosure using the
remaining pair of countersunk M4 hex-head screws and a standard L-shaped hex key. Ensure that
the stabilizer is ‘sandwiched’ between the lower feet and the mounting surface/enclosure by
screwing through the Wire Rope Mount feet, then the stabilizer and into the mounting
surface/enclosure.
Figure 19 - Wire Rope Mounts