TigerStop TigerSaw 1000, Installation Manual

Page: 28 / 68

25
Attach the Kill Line Switch
The kill line switch will attach to the saw guard. Kill line hardware is found in the pack labeled “Kill
Line Hardware”.
1. Mount the kill line switch to the under side of the front bracket as shown. Set the cable aside until
we make the final connections.
2. Loop the red kill line through the kill line switch and use 2 clamps to secure it.
3. Run the red kill line through the eye bolts at the end of each material staging tube.
4. Mount the kill line bracket to the end of the in feed table as shown.
5. Loop the red kill line through the eye bolt at the end of the bracket and use 2 clamps to secure it.
6. Tighten the kill line until the black indicator on the kill line switch is in the middle of the green stripe.