TigerStop TigerSaw 1000, Installation Manual

Page: 29 / 68

26
Final Connections
A Note on Cable Routing
When routing cables, you will want to adhere to a few guidelines;
•Keep data cables and power cables separate.
•Keep cables away from dust collection systems.
•Keep cables away from florescent lighting.
•Keep data cables away from any electrical noise generating devices.
•Do not overtighten any zip ties or other cable management restraints.
•Ensure all cables are routed so that they will not become crushed or pinched.
TigerStop Amp and Controller Connections
1. Ensure TigerStop is powered off.
2. You will have two controller cables. Locate the first controller cable.
3. Plug the silver end of one controller cable into the I/O panel plug labeled “Controller”.
4. Plug the opposite end of this controller cable (black) into the TigerStop controller.
5. Locate the second controller cable.
6. Plug the black end of this cable into the I/O panel port labeled “Amp”.
7. Plug the opposite end of this cable (silver) into the TigerStop motor box.
Mount Controller to Controller Stand
The TigerSaw Guard will come from the factory with the controller stand already attached. Slide the
controller on to the stand and tighten the supplied bolts to hold it in place.
Note: Do not over tighten!
Input/Output Connections
TigerSaw has many connections to the I/O panel input and output plugs. Many of these are con-
nected from the factory. Use the chart below to make the final I/O panel connections.
I/O Plug Goes To Cable Color Number of Pins Cable Label
Interlock In TigerStop Motor
Box
Gray 6 Int In
E-Stop Saw Control Box Brown 4 EStop
Tool At Extension
(TA)
Top Arbor Sensor Gray 4 Tool Ext
Cycle Start
(Edge Detect)
Pusher Foot Gray 4 Edge
Tool At Rest
(UV Det)
Pusher Foot Yellow 4 UV Det
Tool Out
(SE)
Pneumatic Valve
inside saw
Gray 4 T out