Tiernan TE3000, Installation And Operation Manual

Page: 87 / 114

Troubleshooting 77
!
Issuing a remote
FM RELAY_CLR
command
Viewing Fault Relay Log on the Front Panel
To view the fault relay log
on the front panel, perform these steps.
1. From the main menu, select the Status menu.
2. The Status menu displays. Use the right arrow to select Relay.
3. The Fault Relay menu displays. Select List.
4. The most recent fault is displayed. If no faults exist,
No Faults
is displayed.
5. To view all faults in the relay log, press the Up button. If the LCD does not
change, only one fault exits in the log.
Initialization Self-Test
Function
In addition to internal fault monitoring, the TE3000 micro-controller
automatically performs built-in-self-tests during the initialization process. If a
failure is detected, a fault is displayed to alert you to the problem.
If the TE3000 did not display an error message during initialization, but is not
operating properly, perform the following diagnostic steps.
1. Verify that the unit is configured correctly for your requirements.
2. If your system is configured properly, but still not operating correctly, issue
the front panel
CONFIG>PRESETS>RESTORE
command or the
CM
LOAD_DEF
remote command to reset the TE3000 to the defaults.
3. Reset any custom configuration parameters specific for your site.
4. If the TE3000 is still not operating properly, query the current faults to
determine if a current fault exists. Correct all current faults.
5. Query and review the fault history log. Correct all faults, if possible.
6. Clear all faults.
7. Query the current faults and fault history log.
8. If the unit continues to fail, record the fault history. Contact Tiernan Customer
Service for assistance.
SD Encoder
Config [
Status ]
→
Status Menu
[ Relay ]
→
Fault Relay Menu
[ List ]
Clear
→
Fault Relay Log
No Faults