Tiernan TE3000, Installation And Operation Manual

Page: 16 / 114

6 Installing the TE3000
AC wiring must be done in accordance with governmental standards and codes in
effect at the TE3000 installation site. Refer to the Safety Precautions for
additional information.
North American Applications
One cord has an IEC-compatible female
plug on one end and a North American male plug on the other. This cord is UL
and CSA approved up to 12 5VAC at 10A. This cord is ready to use with no user
wiring required.
International Applications
The international cord has an IEC-compatible
female plug on one end and three stripped and tinned bare wires on the other end.
This cord is approved by many international safety agencies, including VDE, up
to 25 0VAC at 6A.
Connecting to a Power Source
To connect to an AC power source, follow these steps:
1. Select an AC power cord. If an international power cord is selected, attach a
connector in accordance with local regulations and laws.
2. Ensure the TE3000 power switch is in the Off, or 0, position.
3. Connect the female plug of the AC power cord to the AC power receptacle on
the TE3000 rear panel.
4. Connect the male plug of the AC power cord to an external A Cpower
conditioning surge suppressor.
5. Connect the AC power conditioning surge suppressor to an A Coutlet.
Corrupted AC input power can interrupt TE3000 operations and cause permanent
damage to the unit. You should purchase and install a commercially available,
external AC power conditioning surge suppressor to protect the TE3000 against
power spikes and line transients.
Power-up Sequence
Once the cabling and interconnections for the TE3000 are completed, you may
power-up the unit. The TE3000 power switch is a rocker switch located on the
front panel.
The power switch is labelled with a — and an
0
. The — represents the On
position, while the
0
represents the Off position.
To power up the TE3000, press the power switch to the ON, or —, position. The
power-on cycle takes approximately three to four minutes to complete, as the unit
performs extensive self-diagnostics in this time period. During the powered-up
cycle, the TE3000 displays
Initializing
, and the tri-colored Status LED
illuminates and may flash. After the unit is initialized, the LCD displays the SD
Encoder main menu.
CAUTION!
Please Read
Carefully
CAUTION!
Please Read
Carefully
SD Encoder
[ Config ]
Status
→