Tiernan TE3000, Installation And Operation Manual

Page: 75 / 114

Configuring the TE3000 65
7. When the LCD displays the SD Encoder main menu, the TE3000 is set to the
selected default configuration.
Using a Remote Unit to Set the Default Configuration
To initialize the TE3000 to the default configuration using a remote unit, issue the
following command:
!
CM LOAD_ DEF <string>
where
<string>
this the correct default parameter, either
DVB
or
ATSC
When the TE3000 is set to the DVB default setting, the remote port baud rate is
set to 38400 bps.
If the remote unit is set to communicate with the TE3000 at a baud rate other than
38400 bps, immediately after the DVB default command is issued, the remote unit
will not be able to communicate with the TE3000. To resolve this issue, the
equivalent parameter in the software settings of the remote unit must be changed
to 38400 bps.
However, the remote unit software settings must not be changed before issuing the
DVB default command to the TE3000, as the remote unit will not be able to
communicate with the TE3000.
Configuration
Examples
All examples presented in this section follow the TE3000 Configuration
Procedure presented at the beginning of this chapter and use the DVB factory
configuration as the default.
Configuring a Basic DSNG Setup Using the Front Panel
This example configures the TE3000 to a basic DSNG setup. Use this example as
a guideline, substituting your site-specific parameter values as required.
Step 1: In this example, assume that the following is a list of your TE3000
operational parameters:
Input channels
!
Audio A: On
!
Audio B: Off
!
Video: On
Audio encoder parameters
!
Source of input audio: analog left and right input
!
Compressed output audio format: stereo
!
Audio compressed bit rate: 256 kbps
!
Audio channel sample rate: 48 kSps
Video encoder parameters
!
Source of input video: composite analog
!
Video format mode: PAL
SD Encoder
[ Config ] Status
→
NOTE...