THUNDER LASER
MINI-60
www.thunderlaser.com
THUNDERLASER TECH CO., LTD
Tel :(86)755 82689501
73
5.7 Troubleshooting
Below are some solutions to this problem
，
we advise customs consult the following
thinking before encounter problems, and hope customs can revise our thinking at any
time.
Laser head impact Limit switch while resetting
----------------------------------------------------------------------------------------------------------------------------- ----
Here are the fault factors:
1. Wrong pulse settings
2. Limit switch type mismatch the laser controller
3. Wiring mistake
----------------------------------------------------------------------------------------------------------------------------- ----
Here are the solutions:
Step 1. Wrong pulse setting
Resetting the pulse equivalent, for how to reset, please refer to the lesson “why cutting size
doesn’t match design size”
Step 2. Limit switch type mismatch laser controller
Our Thunder laser controller support NPN-NO mechanical switch or sensor switch only.
Step 3. Wiring mistake
Please refer to following diagram for how to wiring the limit switch:
1. Mechanical switch 2. sensor switch
Please set the limit switch singal to ”Low Level Effect” in software.
If you want to know more information about troubleshooting, and you can visit our
http://www.thunderlaser.com/technical-support/troubleshooting.html
If you need any other help, just contact with us by sending e-mail to:
End
